Front & Rear Panels; Front Panel; Rear Panel - Onkyo A-1VL Instruction Manual

Front & Rear Panels

Front Panel

1
POWER button
This button is used to set the A-1VL to On or Off.
2
POWER indicator
This indicator lights up when the A-1VL is ON.
While this indicator is illuminated, you can operate
the A-1VL with the remote controller.
3
MUTING indicator
This indicator lights up when the Muting function is
set.
4
VOLUME control
This control is used to set the volume of the A-1VL.

Rear Panel

1
PHONO
These analog inputs can be used to connect a
turntable with a moving-magnet cartridge.
2
TUNER
These inputs can be used to connect a tuner.
3
CD
These inputs can be used to connect a CD player
with analog outputs.
4
PREOUT
If you use the A-1VL as a preamp, these analog pre-
out can be connected to the inputs on a power amp.
5
MAIN IN
If you use the A-1VL as a power amp, these analog
inputs can be connected to the outputs on a separate
preamp.
6
5
Remote control sensor
This sensor receives control signals from the remote
controller.
6
Input selector control
This control is used to select following input
sources: CD, LINE 1, LINE 2, TUNER and
PHONO.
7
DIRECT button
Turns on or off the DIRECT function. When you
use the A-1VL as a power amplifier, turn on the
DIRECT function.
6
SPEAKERS
These terminal posts are for connecting your speakers.
7
Grounding screw
This screw is for connecting a turntable's ground wire.
8
LINE 1
These inputs can be used to connect a TV or other
component with analog outputs.
9
LINE 2 IN/OUT
These analog inputs can be used to connect a
cassette or MD recorder.
0
SPEAKER IMPEDANCE SELECTOR
This selector can be used to set the speaker imped-
ance values according to the speakers you use.
A
AC INLET
The supplied power cord should be connected here.