Table of Contents
Advertisement
chute ring turns with crank. Make sure plastic
bushing is fully inserted into hole in mounting
bracket, then secure mounting bracket to handle
with (2) capscrews and locknuts.
Install Discharge Chute (Fig. 4)
1.
Set discharge chute onto chute ring. Align hole
in back of chute with center hole in ring and
install a carriage bolt and sems locknut. Position
nut on outside of chute.
Note:
Chute ring may be rotated to ease
assembly of discharge chute.
2.
Secure chute to remaining holes in chute ring
and tighten all nuts SECURELY.
Install Handle (Fig. 5)
1.
Remove tie securing control cable to lower
handle.
2.
Position upper handle so that curved control bar
is on top of handle, not underneath it.
3.
Secure upper and lower handle in place with (3)
handle bolts, (1) eyebolt, and (4) locknuts. Use
eyebolt to mount lower left side of handle.
Eyebolt must be positioned perpendicular to
handle when tightened.
Install Control Cable (Fig. 6)
1.
Route control cable through eyebolt and hook
upper end in rear hole (hole with arrow) in
control bar bracket.
2.
Move control bar back toward handle until slack
in cable is removed. The gap between the control
bar bracket and handle should be approximately
1/16"–1/8". See insert, Figure 6. If an
adjustment is required, refer to Adjusting
Control Bar, page 8.
Note:
The control cable must always have
slack in it when in the disengaged
position.
Before Starting
POTENTIAL HAZARD
In certain conditions gasoline is extremely
flammable and highly explosive.
WHAT CAN HAPPEN
A fire or explosion from gasoline can burn
you, others, and cause property damage.
HOW TO AVOID THE HAZARD
Use a funnel and fill the fuel tank outdoors,
in an open area, when the engine is cold.
Wipe up any gasoline that spills.
Do not fill the fuel tank completely full.
Add gasoline to the fuel tank until the level
is 1/4" to 1/2" (6 mm to 13 mm) below the
bottom of the filler neck. This empty space
in the tank allows gasoline to expand.
Never smoke when handling gasoline, and
stay away from an open flame or where
gasoline fumes may be ignited by a spark.
Store gasoline in an approved container
and keep it out of the reach of children.
Never buy more than a 30-day supply of
gasoline.
Mix Gasoline And Oil (Fig. 7)
Use clean, fresh lead-free gasoline, including
oxygenated or reformulated gasoline, with an octane
rating of 85 or higher. To ensure freshness, purchase
only the quantity of gasoline that can be used in 30
days. Use of lead-free gasoline results in fewer
combustion chamber deposits and longer spark plug
life. Use of premium grade fuel is not necessary or
recommended.
1.
APPROVED OIL—For simplicity and best
engine performance, mix the contents of one
5.2–ounce bottle of Toro 50:1 Two–Cycle Oil
5
Hide quick links:
Advertisement
Table of Contents
