Toro 25430A Operator's Manual page 53

Cleaning the Axle Breathers
Service Interval: Every 300 hours
1. Clean the area around the breathers with a cleaning
solvent (Figure 73 and Figure 74).
Figure 73
1. Front axle
2. Breather port
Figure 74
1. Rear axle
2. Breather port
2. Remove the breather from the front axle (Figure 73).
3. Remove the breather from the rear axle (Figure 74).
4. Clean the breathers with a cleaning solvent.
5. Use compressed air to dry the breathers.
3. Breather fitting
3. Breather fitting
Important: Wear face protection when using
compressed air.
6. Install the breather in the front axle (Figure 73).
7. Install the breather in the rear axle (Figure 74).
53