Setup; Installing The Handle - Toro 22191 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Handle

Parts needed for this procedure:
1 Handle
2 Bolt (5/16 x 1-1/4 inches)
4 Washer
2
Thin nylon insert locknut (5/16 inch)
2 Bolt (5/16 x 1-1/2 inches)
1 Carriage bolt
2 Locknut (5/16 inch)
1 Bag support rod
1 Bag aligning plate
3 Cap locknut
3 Cable tie
Procedure
1. Mount the handle to the outside of the mower
housing (using the bottom hole) with two bolts
Description
Handle
Bolt (5/16 x 1-1/4 inches)
Washer
Thin nylon insert locknut (5/16 inch)
Bolt (5/16 x 1-1/2 inches)
Carriage bolt
Locknut (5/16 inch)
Bag support rod
Bag aligning plate
Cap locknut
Cable tie
Discharge tunnel plug
No parts required
Qty.
1
2
4
2
2
1 Install the handle.
2
1
1
3
3
1 Install the discharge tunnel plug.
–
Fill the crankcase with oil.
(5/16 x 1-1/4 inches), washers, and thin locknuts
(5/16 inch) (Figure 3).
1. Bag support rod
2. Carriage bolt
3. Bag aligning plate
4. Cap locknuts (3)
5. Handle
6. Bolt, (5/16 x 1-1/2 inches)
(2)
7. Handle latch (2)
2. Secure the handle latches to the handle with 2 bolts
(5/16 x 1-1/2 inches), washers, and locknuts (5/16
inch) (Figure 3).
7
Use
Figure 3
8. Thin nylon insert locknut
(2)
9. Bottom hole in housing
10. Washer (4)
11. Locknut (2)
12. Bolt, (5/16 x 1-1/4 inches)
(2)
13. Cable tie (3)