Installing The Handle; Loose Parts - Toro 38605 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1.
2.
3.
4.
5.
6.
7.
8.

1. Installing the Handle

1 Handle
4 Bolts
4 Belleville washers
1 Flange nut
Procedure
1. Remove the tie straps that secure the control rods
to the handle.
2. Remove the axle pins from both wheels and slide the
wheels outward on the axle approximately 1 inch (3
cm) (Figure 3).
Description
Handle
Bolts
Belleville washers
Flange nut
Speed selector rod
Cotter pin
Flat washer
Flange locknut
Clevis pin
Cotter pin
Chute control rod assembly (rod and
bracket, worm gear, and bracket)
Carriage bolt
Belleville washer
Hex head bolt
Locknut
No parts required
No parts required
No parts required
Qty.
1
4
Install the handle.
4
1
1
1 Install the speed selector rod.
1
1 Install the traction rod.
1
Install the auger/impeller drive control
linkage.
1
1
1
Install the chute control rod.
1
1
2
–
Fill the engine with oil.
–
Check the tire pressure.
–
Check the skids and scraper.
1. Axle pin (2)
2. Cap screw and curved
washer (4)
7
Use
Figure 3
3. Handle