Removing The Mower - Toro 74723 Operator's Manual

1
1. Adjusting rod
2. Adjusting block
7. To raise the front of the mower, tighten the adjustment
nut. To lower the front of the mower, loosen the
adjustment nut.
8. After adjustment, check the front-to-rear slope again.
Continue adjusting the nut until the front blade tip is
1/16-5/16 inch (1.6-7.9 mm) lower than the rear blade
tip (Figure 56 ).
9. When the front-to-rear blade slope is correct check the
side-to-side level of the mower again; refer to
Side-to-Side (page

Removing the Mower

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin cotter from the front support rod
and remove the rod from the deck bracket
58). Carefully lower the front of the mower deck to
the ground.
3
2
G014634
Figure 57
3. Lock nut
38).
(Figure
3
1. Front support rod
2. Locking nut
5. Lift the mower deck and hanger brackets clear of
the rear lift rod and lower the mower carefully to the
ground
Leveling
2 2
1
1. Mower deck
2. Hanger bracket
6. Slide the mower deck rearward to remove the mower
belt from the engine pulley.
7. Slide the mower deck out from underneath the
machine.
Note: Retain all parts for future installation.
40
Figure 58
3. Deck bracket
(Figure 59).
3 3
Figure 59
3. Rear lift rod
2
1
G014635
2 2
G005077