Lubrication
Greasing the Bearings and
Bushings
The machine has grease fittings that must be lubricated
regularly with No. 2 general-purpose lithium-base grease. If
the machine is operated under normal conditions, lubricate all
bearings and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are:
Traction Unit
Service Interval: Every 50 hours
•
Brake pedal pivot shaft bearings (2)
•
Front and rear axle pivot bushings (2)
•
Steering cylinder ball joints (2)
•
Tie rod ball joints (2)
•
King pin bushings (2)
The top fitting on the king pin should only be
lubricated annually (2 pumps).
Figure 35
Figure 36
(Figure
35)
(Figure
36)
(Figure
37)
(Figure
37)
(Figure
37).
Front Cutting Unit
•
Castor fork shaft bushings (2)
•
Spindle shaft bearings (3) (located under the pulley)
(Figure
39)
•
Idler arm pivot bushings (2)
39
Figure 37
(Figure
38)
(Figure
39)
Figure 38