Declaration Of Conformity - Onkyo SKS-HT530 Instruction Manual

7.1ch home theater speaker package

Hide thumbs Also See for SKS-HT530:

Service manual (25 pages)

Table Of Contents

Table of Contents

Available languages

Thank you for purchasing an Onkyo home theater speaker package. Please read this manual thoroughly

before using your new speakers. Following the instructions in this manual will enable you to obtain opti-

mum performance and listening enjoyment from your speaker package.

Please retain this manual for future reference.

Precautions

1. AC Fuse

The fuse is located inside the chassis and is not userser-

viceable. If power does not come on, contact your Onkyo

authorized service station.

2. Care

From time to time you should wipe off the cabinet with a

soft cloth. For heavier dirt, dampen a soft cloth in a weak

solution of mild detergent and water, wring it out dry, and

wipe off the dirt. Following this, dry immediately with a

clean cloth. Do not use rough material, thinners, alcohol

or other chemical solvents or cloths since these may dam-

age the ﬁnish or remove the panel lettering.

Use a vacuum cleaner to remove dust from hard-to-reach

grilles.

3. Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE

FIRST TIME, READ THE FOLLOWING SECTION

CAREFULLY.

The voltage of the available power supply differs

according to country or region. Be sure that the power

supply voltage of the area where this unit will be used

meets the required voltage (e.g., AC 120 V, 60 Hz) writ-

ten on the rear panel.

Auto standby function does not fully shutdown the

SKW-530. If you do not intend to use the SKW-530,

remove the power cord from the AC outlet.

For British models

Replacement and mounting of an AC plug on the power

supply cord of this unit should be performed only by

qualiﬁed service personnel.

IMPORTANT

The wires in the mains lead are coloured in accordance

with the following code:

Blue:

Neutral

Brown:

Live

■ Attaching and detaching the speaker grilles

Front and Center speakers have detachable grilles. Use the

following method to attach or detach the grilles.

1. While holding the bottom edge of the speaker grille

with your both hands, pull it gently toward you to

remove the bottom of the grille.

2. In the same way, gently pull the upper edge of the

speaker grille toward you to remove it from the main

unit.

3. To replace the grill, push the projections at the corners

into the grille plug holes on the speaker cabinet.

As the colours of the wires in the mains lead of this

apparatus may not correspond with the coloured mark-

ings identifying the terminals in your plug, proceed as

follows:

The wire which is coloured blue must be connected to

the terminal which is marked with the letter N or

coloured black.

The wire which is coloured brown must be connected to

the terminal which is marked with the letter L or

coloured red.

IMPORTANT

The plug is ﬁtted with an appropriate fuse. If the fuse

needs to be replaced, the replacement fuse must

approved by ASTA or BSI to BS1362 and have the same

ampere rating as that indicated on the plug. Check for

the ASTA mark or the BSI mark on the body of the fuse.

If the power cord's plug is not suitable for your socket

outlets, cut it off and ﬁt a suitable plug. Fit a suitable

fuse in the plug.

For European Models