Parking Brake; Installing Or Removing Baffles - Toro 74270 Operator's Manual

Operation

Parking Brake

Always set the parking brake when you stop the
machine or leave it unattended.
IMPORTANT: Do not park on slopes unless
wheels are chocked or blocked.
Setting the Parking Brake
1. Move the motion control levers (Fig. 1) out to
the neutral lock position.
2. Pull back and up on the parking brake lever to
set the parking brake (Fig. 2). The parking brake
lever should stay firmly in the "ENGAGED"
position.
Releasing the Parking Brake
1. Push forward and down on the parking brake
lever to release the parking brake (Fig. 2). The
parking brake is "DISENGAGED".
1
2
Figure 2
1. Parking brake-ON
22
m–4121
2. Parking brake-OFF

Installing or Removing Baffles

The following instructions are for removing and
installing baffles. The baffles are used for mulching
only. It is written as though you were to install the
baffles. Reverse the procedures to remove them.
Pre–Installation
POTENTIAL HAZARD
Blade is sharp.
WHAT CAN HAPPEN
Contact with sharp blade can cause serious
personal injury.
HOW TO AVOID THE HAZARD
Wear gloves or wrap sharp edges of the
blade with a rag.