Troubleshooting Guide; If The Antenna Connector Doesn't Match; Changing Rf Output Channel; To Reset This Unit - Panasonic DMR-EZ485V Operating Instructions Manual

Troubleshooting Guide

If the Antenna Connector doesn't Match

Use the following connection to suit the antenna lead to
the unit's RF IN terminal, and the 75  coaxial cable to the
antenna terminals on your TV or other equipment. Refer to the
other equipment's operating instructions for more information.
This unit
from the antenna
(Flat) Twin lead
300  cable
Other equipment (television etc.)
75−300  transformer
75  coaxial
cable

Changing RF Output Channel

If you connected this unit and a TV without an audio/video
cable, interference (lines or patterning) or a very poor picture
may appear on the TV. If this happens, follow the steps below
to change the video playback channel (RF output channel) to
remove the interference.
Press and hold
for more than
5 seconds.
– The RF output
channel number
displays on the
unit's display.
TRACKING/V-LOCK
CH
The unit's display
Each time you press the button:
CH 3 (Default setting)  CH 4  OFF

For connections with the audio/video cable, set the RF
output channel to "OFF".
OK
Notes
When you set the RF output channel to "CH 3" or "CH 4"
Video from this unit can be viewed on channels 3 and 4 on
the TV. Press [VCR/TV] to switch to VCR mode and output
video from this unit (
Downloaded From Disc-Player.com Panasonic Manuals
300−75  transformer
To this unit's RF
IN terminal
VHF or UHF
Television
RF Output Channel
Press the channel up/down buttons
to select a RF Output Channel.
Ch.
OK
to select "CH 3" or "CH 4".
to fi nish.
16).

To Reset This Unit

To reset the channel information and the
clock settings
On the main unit
CH CH
To reset the ratings level settings
You can reset both parental rating (
DVD-Video rating (
With the unit stopped
OPEN/CLOSE
On the main unit
3 Press and hold both buttons for
about 5 seconds.
To restore the unit if it freezes
On the main unit
Press and hold for more than
POWER
10 seconds.
–The unit is off.
or
On the main unit
RESET
Press and hold both buttons
for about 5 seconds.
56) and
59).
to open the disc tray.
CH CH REC
SD CARD
Press and hold for
more than 1 second
with a pointed object.
81