Toro 74919TE Operator's Manual page 58

Figure 87
1. Deck-lift pedal
2. Height-of-cut pin
6. Insert the height adjustment pin into the 7.6 cm (3
inch) cutting-height location.
7. Release the transport lock and allow the deck to lower
to the cutting height.
8. Raise the discharge chute.
9. On both sides of the deck, measure from the level
surface to the front tip of the blade (Position A).
Note: The measurement should read 7.6 mm (3
inches); refer to Figure
Figure 88
1. 7.6 cm (3 inches) at A is
correct
2. 8.3 cm (3-1/4 inches) at B
is correct
3. Transport lock
88.
3. Measure here from the
blade tip to hard surface
4. Measure at A and B on
both sides
10. Fine-tune the adjustment nut on the front deck lift
assembly by turning it
Note: To increase the height, turn the adjustment
nut clockwise; to decrease the height, turn the nut
counterclockwise.
2
1
G012430
1. Adjustment nut
2. Jam nut
11. If the front deck links do not have enough adjustment
to achieve accurate cut height, the single point
adjustment can be utilized to gain more adjustment.
12. To adjust the single point system, loosen the 2 bolts at
the bottom of the height-of-cut plate. Refer to
90.
58
(Figure 89).
3 4
2 1
Figure 89
3. Rear deck adjustment
4. Front deck adjustment
Figure