Table of Contents
Advertisement
DISASSEMBLING PROCEDUERS (DVD MECHANISM) -1
NOTES IN RE-ASSEMBLING PROCEDURES OF DWG ASY CAROUSEL
Montage of the ASY DRAWER to ASSY BASE
VIEW "Z"
SCREW ST 3 x 8
(3x)
DRIVER MOMENT
42 N/cm +/-2 N /cm
SUPPORT DRAWER
Stop-rip on the DRAWER
Stop-rip on the BASE for
the DRAWER
Contrl-window:
For mounting of the
DRAWER to the BASE, in
this window must be look
the pin of the GEAR MAIN.
VIEW "Z"
Control:
That are LUBRICANT GREASE
inside the two slots and
along on the top area of the
DRAWER
Put in this direction the SUPPORT
DRAWER under the DRAWER under
the DRAWER in the mounting position
SUPPORT DRAWER
SCREW ST 3 x 8
(3x)
DRIVER MOMENT
42 N/cm +/-2 N /cm
Stop-rip on the DRAWER
Montage of the PLATTER
Stop edge on the BASE
for the DRAWER
PLATTER TC5E
Note:
Mounting the PLATTER
if the DRAWER is inside,
the Position of a DISK-
mark must be middle
of the PUCK LOAD.
RUCK LOAD
SCREW ST 3 x 10.black
DRIVER MOMENT
42 N/cm +/-2 N/cm
DR-C500
Position of the CABLE
from PCB SENSOR BOARD
Position of the LABEL
from the assemble supplier
Advertisement
Table of Contents
