Controlling Other Onkyo Components; Preprogrammed Remote Control Codes; Entering Remote Control Codes - Onkyo AVX-280 Instruction Manual

Controlling Other Onkyo Components

You can use the AV receiver's remote controller
(RC-762M) to control your other Onkyo AV components.
This section explains how to enter the remote control code
for a component that you want to control: DVD, CD, etc.
Preprogrammed Remote Control
Codes
The following REMOTE MODE are preprogrammed
with remote control codes for controlling the components
listed. You do not need to enter a remote control code to
control these components.
For details on controlling these components, see the pages
indicated.
BD/DVD Onkyo Blu-ray Disc player
TV/CD Onkyo CD player
PORT Onkyo Universal Port Option

Entering Remote Control Codes

You'll need to enter a code for each component that you
want to control.
1
Look up the appropriate remote control code in
the Remote Control Codes for Onkyo Compo-
nents Connected via u.
2
While holding down REMOTE MODE to which
you want to enter a code, press and hold down
DISPLAY (about 3 seconds).
Note
• Remote control codes cannot be entered for RECEIVER.
• Apart from RECEIVER, remote control codes from any
category can be entered for REMOTE MODE. However,
these buttons also work as input selector buttons
so choose a REMOTE MODE that corresponds with the
input to which you connect your component. For example,
if you connect your CD player to the CD input, choose
TV/CD when entering its remote control code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered success-
fully, the remote indicator will flash once slowly.
En
42
(➔ 43)
(➔ 43)
(➔ 40)
(➔ 21),
Remote Control Codes for Onkyo
Components Connected via u
Onkyo components that are connected via u are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Onkyo component is connected
with an u cable and an analog audio cable
(RCA).
See "Connecting Onkyo u Components" for
details (➔ 18).
2
Enter the appropriate remote control code for
REMOTE MODE.
• BD/DVD
31612:
Onkyo DVD player with u
• TV/CD
71327:
Onkyo CD player with u
42157:
Onkyo cassette tape deck with u
• PORT
81993:
Onkyo Dock
See the previous section for how to enter remote
control codes.
Note
• When using a cassette tape deck connected via u, press
and hold TV/CD to switch to TAPE.
3
Press REMOTE MODE, point the remote control-
ler at the AV receiver, and operate the component.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via u, use the
following remote control codes:
• BD/DVD
30627:
Onkyo DVD player without u
• TV/CD
71817:
Onkyo CD player without u
11807:
Onkyo TV