Operating The Ignition Switch; Using The Fuel Shut-Off Valve; Starting And Stopping The Engine - Toro GrandStand 74583 Operator's Manual

Operating the Ignition Switch

1. Turn the ignition key to the Start position
When the engines starts, release the key.
Important: Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, allow a 15 second cool-down period between
attempts. Failure to follow these instructions can
burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
2. Turn the ignition key to stop to turn off the engine.
(Figure
G008947
Figure 12

Using the Fuel Shut-off Valve

12).
Close the fuel shut-off valve for transport, maintenance, and
storage (Figure 13).
Ensure that the fuel shut-off valve is open when starting the
engine.
1
2
1. On position
Starting and Stopping the
Engine
Starting the Engine
1. Connect the wires to the spark plugs.
2. Open the fuel valve.
3. Move the right motion-control lever to neutral locked
position.
4. Set the parking brake; refer to Setting the Parking
Brake.
5. Move the blade-control switch (PTO) to the Off
position.
6. Move the throttle lever midway between the Slow and
Fast positions.
17
g017735
G008948
Figure 13
2. Off position