Throttle Control; Ignition Switch - Toro GrandStand 74583 Operator's Manual

The battery light turns on when the ignition is turned on and
when the charge is below the correct operating level
6).
1. Safety-interlock symbols
2. Battery light

Throttle Control

The throttle control is variable between Fast and Slow.
Electronic-Control Unit
Malfunction-Indicator Light
The electronic-control unit (ECU) continuously monitors the
operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction-indicator light (MIL) is illuminated.
The MIL is the red light located in the console panel.
Once the MIL illuminates, initial trouble shooting checks
should be made.
If these checks do not correct the problem, further diagnosis
and servicing by an Authorized Service Dealer is necessary.
Choke
Use the choke to start a cold engine.
Blade-Control Switch (PTO)
The blade-control switch (PTO) is used to engage the
electric clutch to drive the mower blades with the right side
motion-control lever in the center, unlocked position. Pull
the switch up to engage the blades and release. To disengage
the blades, push the blade-control switch (PTO) down or
move or release the right side motion-control lever into the
neutral-lock position.

Ignition Switch

This switch is used to start the mower engine and has three
positions: Off, Run and Start.
Figure 6
3. Hour meter
Motion-Control Levers
(Figure
The motion-control levers are used to drive the machine
forward, reverse, and turn either direction.
Fuel Shut-off Valve
Close the fuel shut-off valve (located behind the operator
cushion on the right-hand side of the fuel tank) when
transporting or storing the mower.
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
13