Safety And Instructional Decals - Toro CCR Powerlite 38172 Operator's Manual

•
Rotating rotor blades can injure fingers or hands.
Stay behind the handles and away from the discharge
opening while operating the snowthrower. Keep your
face, hands, feet, and any other part of your body or
clothing away from moving or rotating parts.
•
Before adjusting, cleaning, repairing, and inspecting
the snowthrower, and before unclogging the discharge
chute, stop the engine, remove the key, and wait for
all moving parts to stop.
•
Use a stick, not your hands, to remove obstructions
from the discharge chute.
•
Before leaving the operating position, stop the engine,
remove the key, and wait for all moving parts to stop.
•
Do not wear loose-fitting clothing that could get caught
in moving parts.
•
If a shield, safety device, or decal is damaged, illegible,
or lost, repair or replace it before beginning operation.
Also, tighten any loose fasteners.
•
Do not smoke while handling gasoline.

Safety and Instructional Decals

Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals.
104-2767
104–2768
•
Do not use the snowthrower on a roof.
•
Do not touch the engine while it is running or soon
after it has stopped because the engine may be hot
enough to cause a burn.
•
Perform only those maintenance instructions described
in this manual. Before performing any maintenance,
service, or adjustment, stop the engine, remove the
key, and disconnect the wire from the spark plug. If
major repairs are ever needed, contact your Authorized
Service Dealer.
•
Do not change the governor settings on the engine.
•
When storing the snowthrower for more than 30 days,
drain the fuel from the fuel tank to prevent a potential
hazard. Store fuel in an approved fuel container.
Remove the key from the ignition switch before storing
the snowthrower.
•
Purchase only genuine Toro replacement parts and
accessories.
3
104–2769