Install Motion Control Levers; Installing Seat; Activate The Battery - Toro 74241 Operator's Manual

Install Motion Control Levers

1. Remove the (4) 3/8-16 x 1 (26 mm) bolts and (4) 3/8"
spring washers which attach the motion control levers
to the control arm shafts for shipping (Fig. 3).
2. Place the levers (with the mounting plate toward the
rear) on the outside of the control arm shaft and secure
with (4) 3/8-16 x 1 (26 mm) bolts and (4) 3/8 spring
washers (Fig. 3).
3. Position the levers so the bolts are in the center of the
slots on the lever mounting plate and tighten until
snug.
4. Align the front\rear position of the levers, with each
other, in the neutral position. Loosen hardware and
adjust by sliding/tilting the lever(s) forward or
backward until properly aligned (Fig. 3).
2
3
Figure 3
1. Mounting plate
2. Bolt 3/8-18 x 1 (26 mm)
5. If the ends of the levers hit against each other, while in
the drive position (Fig 4) (levers rotated in as far as
possible) make adjustments by moving the levers
outward to the neutral lock position and carefully bend
them outward. Move them back to the drive position
and check for clearance. Repeat if necessary.
Figure 4
1
m–3751
3. Spring washer 3/8

Installing Seat

1. Remove seat from crate.
2. Position seat on the studs in the adjustable tracks
(Fig. 5).
3. Install nuts onto studs (Fig 5).
1. Seat
2. Studs

Activate the Battery

Bulk electrolyte with 1.260 specific gravity must be
purchased from a local battery supply outlet.
1. Tilt seat up.
2. First disconnect the negative battery cable and ground
wire from the negative (–) battery terminal.
3. Slide the red terminal boot off the positive (red)
battery terminal. Then remove positive (red) battery
cable.
4. Remove battery hold down clamp.
Important
Be careful not to damage the long vent
tube when removing the battery box.
15
Figure 5
3. Adjustable track
4. Nuts