Spark Plug - Toro 74241 Operator's Manual

With 72" sfs side discharge mower
Hide thumbs Also See for 74241:
Table of Contents

Advertisement

1
Figure 26
1. Oil drain plug
5. Slowly pour approximately 80% of the specified oil,
on page 33, into the filler cap (Fig. 25). Now check the
oil level; refer to Checking Oil Level, page 33. Slowly
add additional oil to bring to "FULL" mark on
dipstick.
Change Oil Filter
Replace the oil filter every 200 hours or every other oil
change.
Note: Change oil filter more frequently when operating
conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to
Changing/Draining Oil, page 33.
2. Remove the old filter and wipe the filter adapter
(Fig. 27) gasket surface.
3. Pour new oil of the proper type in through the center
hole. Stop pouring when the oil reaches the bottom of
the threads. Allow a minute or two for the oil to be
absorbed by filter material.
4. Apply a thin coat of new oil to the rubber gasket on
the replacement filter (Fig. 27).
1
Figure 27
1. Oil filter
2. Gasket
5. Install the replacement oil filter to the filter adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 1/2 turn (Fig. 27).
6. Fill the crankcase with the proper type of new oil;
refer to Engine Oil, page 33.

Spark Plug

Check the spark plug(s) after every 200 operating hours.
Make sure the air gap between the center and side
electrodes is correct before installing the spark plug. Use a
spark plug wrench for removing and installing the spark
plug(s) and a gapping tool/feeler gauge to check and
adjust the air gap. Install a new spark plug(s) if necessary.
Type: Champion Premium Gold 2071 (or equivalent)
Air Gap: 0.030 in. (0.76 mm)
Removing the Spark Plug
1. Disengage the power take off (PTO) and turn the
ignition key to "OFF" to stop the engine. Move levers
to neutral locked position and apply parking brake.
Remove the key.
2. Pull the wire(s) off the spark plug(s) (Fig. 28). Now
clean around the spark plug(s) to prevent dirt from
falling into the engine and potentially causing damage.
3. Remove the spark plug(s) and metal washer.
34
3
2
m–1256
3. Adapter
(s)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z286e

Table of Contents