Toro 70185 Operator's Manual page 34

Problem
The machine does not drive.
The cutting height is uneven.
The cutting quality is poor.
The grass collector fails to fill.
Possible Cause
1. The traction belt is worn, loose, or
broken.
2. The traction belt is off the pulley.
3. The transmission does not shift.
1. The tire pressure is incorrect.
2. The mower is not level.
3. The underside of the mower is dirty.
1. The cutting blade is worn.
2. The cutting height is incorrect.
1. The cutting height is too low.
2. The grass is too heavy or damp.
3. The cutting blade is worn.
4. The grass is too high.
5. The discharge area is blocked.
34
Corrective Action
1. Contact an Authorized Service Dealer.
2. Contact an Authorized Service Dealer.
3. Contact an Authorized Service Dealer.
1. Set the tire pressure.
2. Level the mower.
3. Clean under the mower.
1. Sharpen or replace the cutting blade.
2. Adjust the cutting height.
1. Raise the cutting height.
2. Wait until the grass has dried.
3. Sharpen or replace the blade.
4. Raise the cutting height.
5. Remove the obstruction from the
discharge area.