Table of Contents
Advertisement
9. Install the blade, the accelerator, the anti-scalp cup,
and the 2 blade nuts.
10. Turn the lawn mower upright.
11. Connect the wire to the spark plug.
Cleaning under the Belt Cover
Keep the area under the belt cover free of debris.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug (Fig. 6).
3. Remove the bolts that secure the belt cover to the lawn
mower housing (Fig. 27).
1
Figure 27
1. Belt cover
4. Lift off the cover and brush out all the debris around
the belt area.
5. Install the belt cover.
6. Connect the wire to the spark plug.
Lubricating the Pivot Arms
After every 25 operating hours or when the season ends,
lubricate the pivot arms.
1. Move the rear wheel cutting height levers to the center
setting.
2. Wipe the grease fittings with a clean rag (Fig. 28).
1. Grease fitting
3. Install a grease gun onto the fitting and gently apply
m-224
two or three pumps of #2 multi-purpose lithium base
grease (Fig. 28).
Note: Applying grease with excessive pressure may
damage the seals.
Adjusting the Self-propel Drive
If the lawn mower does not self-propel or has a tendency
to creep forward when the control bar is more than 1-1/2
inches (3.8 cm) from the handle, adjust the wheel drive
control knob on the rear of the gear box (Fig. 29).
1. Control knob
1. Close the door in the lawn mower housing and remove
the grass bag.
2. Rotate the control knob clockwise !/2 turn if the lawn
mower does not self-propel. If the lawn mower creeps
forward, rotate the knob !/2 turn counterclockwise
(Fig. 29).
22
1
m-232
Figure 28
1
Figure 29
m-228
Advertisement
Table of Contents
