Toro 22155 Operator's Manual page 7

Note: You can set the handle height in one of two
positions (Figure 5). Set the handle to a height that is
comfortable for you.
1. Higher handle position
Note: Torque all bolts to 120 in-lb (13.6 N·m).
3. Route the blade brake cable down the inside of the
handle and attach the cable end (Figure 6).
1. Attach cable Z-fitting end
here
2. Insert cable jacket end
here
4. For self-propel models, route the self-propel drive
cable down the inside of the handle, thread the cable
through the opening on the left hand side of the
housing, and attach the cable end (Figure 7).
Figure 5
2. Lower handle position
Figure 6
3. Blade brake cable
1. Self-propel drive cable
2. Insert cable jacket end
here
5. Ensure that the self-propel drive is properly adjusted.
Refer to Adjusting the Self-propel Drive in the
Maintenance section.
6. Tie the loose cables to the handle (Figure 8) using
the cable tie from the loose parts bag.
7. Install the back cover with the two screws you
removed in step 1.
7
Figure 7
3. Attach cable end here
Figure 8