Cutterhead Position Control; Dual Lift Configuration Control - Toro 652D Operator's Manual

1.36

CUTTERHEAD POSITION CONTROL

The cutterheads may be raised or lowered using the bank of 3 lift control
levers.
To lower the cutterheads, operate the lift control levers in a downward
direction until locked in position 1. If the cutterhead drive switch is in the
'ON' position, the cylinder drive will engage when the cutterheads are
approximately 300mm above ground level.
IMPORTANT: PREVENT DAMAGE - The lift control levers must be
locked in position 1 while mowing. NEVER mow with the lift control
levers in position 2 (neutral).
To raise the cutterheads, operate the lift control levers in an upward direction
and hold in position 3. If the cutterhead drive switch is in the 'ON' position,
the cylinder drive will disengage when the cutterheads are approximately
300mm above ground level.
cutterheads are at the required height. The control levers will automatically
return to position 2 (neutral).

DUAL LIFT CONFIGURATION CONTROL

The dual lift configuration control function enables the lift controls to be
used in two ways as follows:
Five gang mode, lift configuration (1):
Control switch in position 1
LH lift lever (3) controls LH wing cutterhead
Centre lift lever (4) controls LH front + centre + RH front cutterheads
RH lift lever (5) controls RH wing cutterhead
Three/five gang mode, lift configuration (2):
Control switch in position 2
LH lift lever (3) controls LH wing + LH front cutterheads
Centre lift lever (4) controls centre cutterhead
RH lift lever (5) controls RH wing + RH front cutterheads
With the LH and RH wing cutterheads locked in the fully raised
transport position.
Control switch in position 2
LH lift lever (3) controls LH front cutterhead
Centre lift lever (4) controls centre cutterhead
RH lift lever (5) controls RH front cutterhead
OPERATING THE MOWER
Release the lift control levers when the
1.36
4A953B03A
1
2
3
6
4 5
1. Down / float
2. Neutral
3. Raise
4. LH Wing or LH Wing+LH Front*
5. Centre+LH/RH Front or Centre*
6. RH Wing or RH Wing+RH Front*
*Depending on which lift configuration
is selected. Refer-Dual Lift Configuration
Control.
1
2
3D95301
4A953B03B
5
3 4
1. 5 Gang Mode
2. 3/5 Gang Mode
3. LH Lift Lever
4. Centre Lift Lever
5. RH Lift Lever