Storage - Toro 09701 Operator's Manual

8. Remove (8) capscrews and flat washers securing end
cover and bearing housing to end of aerator frame
(Fig. 34).
Figure 34
1. End cover
9. Loosen bearing set screws (Fig. 35).
1
Figure 35
1. Bearing
10. Remove end cover and bearing.
Note: Remove only the end cover necessary to access
belts being removed, i.e.
Model 660
Left cover – Left belts
Right cover – Center and Right belts
Model 880
Left cover – Left & left center belts
Right cover – Right and Right center belts
11. Slide belts off driven and driver pulleys.
12. Remove belts from aerator by routing them over drive
shaft, thru holes in frame center plates, over bearings
and out hole in end of frame.
Important When changing belts, always change all (3)
belts on the pulley.
13. Route new belts over drive shaft and onto pulleys.
14. Reinstall end cover onto drive shaft. At location
marked on frame, loosely secure end cover to aerator
frame with (8) capscrews and flat washers removed.
15. Reinstall bottom of tine arm to bottom links or rotalink
arm with fasteners removed.
1
16. Reinstall top of tine arm to pulley with screw, lock
washer and flat washer.
17. Secure idler pulley assembly to idler pivot shaft with
hair pin cotter.
18. Secure top of spring assembly to frame with idler pin
and hair pin cotter.
19. Adjust belt tension. Refer to Adjusting Belt Tension.

Storage

At the end of an aerating season or when the aerator will
not be used for a long period, it is good practice to carry
out the following preventative maintenance.
1. Clean off any dirt or grease that may have
accumulated on the aerator or any of the moving parts.
2. Remove the tines and clean out hollow tines. Coat
tines with oil to prevent rusting during storage.
3. Open the hood and clean out the inside of the machine.
4. Lubricate all grease fittings.
5. Store the machine with the roller and castor wheel
standing on a hard, dry surface or board and block the
roller.
6. Remove PTO drive shaft and store under hood
7. Paint the roller and touch–up any other scratches on
the paintwork.
8. Replace any missing or damaged decals.
9. Store the aerator inside a dry secure building. Inside
storage will reduce maintenance, give a longer
working life and increase the residual value of the
machine. If inside storage is not available, cover with
a heavy sheet or tarpaulin and secure tightly.
27