Operating Tips - Toro 74391 Operator's Manual

Hide thumbs Also See for 74391:
Table of Contents

Advertisement

Figure 20
1. Knob
2. Curved washer
5. Remove the right baffle and lower the grass
deflector over the discharge opening as shown in
Figure 21 and Figure 20.
Figure 21
1. Right baffle
2. Curved washer and knob
6. Install the fasteners into the holes in the top of the
mower to prevent flying debris.
3. Baffle stud coming through
the mower
1
2
4
3
1
G006475
3. Discharge opening
4. Tab (must remain outside
of the mower)
Open holes in the mower expose you and others
to thrown debris which can cause severe injury.
• Never operate the mower without hardware
mounted in all holes in the mower housing.
• Install the hardware in the mounting holes
when you remove the mulching baffle.
7. Install the right mower blade. Refer to the Mower
Maintenance section.
8. Lower the grass deflector over the discharge
opening.
Important: Ensure the mower has a hinged
grass deflector that disperses clippings to the
side and down toward the turf, while in side
discharge mode.
Installing the Right Baffle for Mulching
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to park
position, stop the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the right mower blade. Refer to the Mower
Maintenance section.
4. Slide the right baffle through the discharge opening
and secure it using 2 knobs and curved washers
(cupped side facing the mower) as shown in
Figure 20 and Figure 21.
Important: Ensure that the tab on the far right
side of the right baffle is outside of the mower
and is flush with the mower wall.
5. Install the right mower blade. Refer to the Mower
Maintenance section.

Operating Tips

Fast Throttle Setting
For best mowing and maximum air circulation, operate
the engine at the Fast position. Air is required to
thoroughly cut grass clippings, so do not set the
height-of-cut so low as to totally surround the mower
by uncut grass. Always try to have one side of the
mower free from uncut grass, which allows air to be
drawn into the mower.
20

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Timecutter z5000

Table of Contents