Toro Power Shovel 38310 Operator's Manual page 4

Note: If the internal wiring blocks the hole, gently move
the wiring to one side using the shipping wire. (Discard
the shipping wire after completing the assembly.)
5. Loosely secure the adjustable handle to the tube with
the carriage bolt and knob (supplied in loose parts bag)
as shown in Figure 4.
6. Move the adjustable handle to the desired operating
position by sliding the handle to the desired height and
tightening the knob.
Attaching the Power Head
1. Position the power head and the handle support as
shown in Figure 5A.
2. Pull the power head connector out of the motor
housing hole.
3. Assemble the power head connector and the handle
connector by sliding the connectors together (Fig. 5A)
until they snap.
Note: There is only one way to fit the connectors together.
4. Push the connectors into the motor housing hole.
5. Make sure the handle support is positioned as shown in
Figure 5B (the Toro Power Shovel decal should be
facing up). Slide the handle support over the power
head. Make sure the grooves in the handle support and
power head are interlocked (Fig. 5B).
IMPORTANT: If the handle support does not slide
completely into position, check the electrical wiring
and connectors to ensure they are inside the motor
housing hole and not interfering with the assembly.
6. Insert a 1/4-in. x 1-in. Phillips head screw (supplied in
loose parts bag) through the hole in the rear of the
handle support (Fig. 5B) and screw securely into the
motor housing. Repeat with the second screw.