Polishing Your Hard Floors - Shark SONIC DUO SP600Q Owner's Manual

Using Your Sonic Duo
IMPORTANT: NEVER add the Sonic
Activated Wood & Hard Floor Polish to
the Reusable Bottle or run it through the Sonic
Duo unit.
™
fig. 22

Polishing Your Hard Floors:

1
Vacuum the floor to remove all loose dirt, dust
and grit from the floor surface. For best results,
we recommend that you clean the floor using
the Shark Wood & Hard Floor Cleaner first and
®
allow time to dry before polishing.
2 Attach the Hard Floor Polishing Pad to the
bottom of the Sonic Duo
"Orange" trim and the "Orange" tag says "Hard
Floor Polishing Pad". (Fig. 22)
3 Lightly step on the back of the scrubbing head to
release the handle.
WARNING: Never stand on the Sonic Duo
4
Carefully, squirt a liberal amount of the Floor
Polish onto an area of the floor to be polished
and place the polishing pad over it before you
start the unit. Make sure that the polishing pad
is saturated and then squirt the polish in 5'x5'
sections. (Fig. 23)
5 Turn the On/Off button to "(I) Hard Floor"
mode. Always squirt the floor polish from a
height of 6 inches above the floor to avoid
splashing the polish over the floor. One bottle is
enough to cover 425 square feet. (Fig. 24)
8 TOLL FREE: 1-800-798-7398
- cont.
™
fig. 23
. This pad has a
™
.
™
fig. 24
fig. 25
6 Use the Sonic Duo
™
evenly over the floor. Do not go over an applied
area too frequently. Always leave an area
looking wet. If a section begins to look dry while
polishing, add more Wood & Hard Floor Polish to
the area. Repeat until the whole area has been
polished.
7 When going from section to section, do not lift
the Sonic Duo to move it, always slide it to
™
the next section. No rinsing is required.
8
Allow the Wood & Hard Floor Polish to dry for at
least 1 hour in light traffic areas and a complete
24 hours for the polish to cure before returning
to heavy traffic areas.
9 When finished, turn the unit off and slide and
lift the Sonic Duo
™
that was just polished. Lay the Sonic Duo
its side and remove the Hard Floor Polishing Pad
by hand. (Fig. 25)
NOTE: Depending on the amount of traffic your
floors sustain, Shark
every 2 months. Touch up high traffic areas as
needed in-between full floor polishes.
to spread the polish
to remove it from the area
on
™
recommends polishing
®