Initial Setup - Magnavox 40MV336X Owner's Manual

These Operations are accessible by Remote Control.
Some may also be accessible by the Main Unit's Control Panel.

Initial Setup

This section will guide you through the Unit's Initial setting which includes
selecting a Language for your On-screen Menu, country, location and
Autoprogram, which Automatically scans and memorizes viewable
channels. You can also set the network connection in this setting.
Before you begin:
Make sure the Unit is connected to an Antenna or Cable.
1
After making All the Necessary Connections, press B to Turn On
the Unit.
It may take a few moments to Turn On the Unit for the first time.
●
Initial setup menu appears Automatically after the Unit is Turned
●
On.
2
Use H I to Select the on-screen language, country, TV placement
and location in the middle of the TV screen, then press OK.
You must set Home in location setting. Otherwise, Picture and
●
Sound settings you adjusted will not be memorized after the Unit
goes into Standby mode.
3
Use J K to Select Skip or Next on Network setup screen.
4
Use H I to Select Wireless or Wired, then press OK.
Installation
This TV can be connected to your
home network.
Select your connection type.
12 34
Skip
If you have a Wireless Router, select Wireless to
Wireless
connect to the Internet.
If you connect with an Ethernet Cable, select Wired
Wired
to connect to the Internet.
If you have a router with easy connect function, select Wireless
●
and use H I to Select Simple Connect, then press OK.
5
Follow the on-screen instructions to complete the installation.
When you select On in the selection screen for Auto software
●
update, A message will appear later if there is the latest software
on the network server.
Wireless
Wired
56 7
6
Use H I to Select the signal type.
If the TV is connected to a Cable or Satellite Set-top Box, select
●
the 2nd one and skip to step 8.
Installation
Select "Antenna" to set up a TV signal
from a cable TV wall jack or a standard
TV antenna.
Select "Set-top box" to set up a TV signal
from a cable TV box
or satellite TV receiver.
12 34 56
7
Use H I to Select Antenna for TV channels or Cable for CATV
channels, then press OK.
Installation
Make sure that you have attached your
antenna or cable signal into the jack on
the back of your TV labeled
"ANTENNA IN".
Now select either Antenna or Cable,
using up/down key of the remote
control. Once you have made your
selection, press the OK button to
12 34 56
proceed.
When Antenna is selected, the TV detects Antenna signals. It
–
searches for DTV and Analog TV channels available in your area.
When Cable is selected, the TV detects signals supplied by
–
cable. It searches for DTV, Analog TV and Cable channels
available in your area.
Auto programming will begin.
●
Installation
System searching. Please wait...
Auto programming may take more than
20 minutes to complete.
Digital channels will take longer than
Analog to find and program.
Please wait until you see the Auto
Programming complete message.
12 34 56
Stop
17 .
English
Antenna
Set-top box
7
Antenna
Cable
Skip
7
Digital channels found: 0
Analog channels found: 0
Total progress:
7
Continued on next page.