Toro 74939 Operator's Manual page 54

With 60in and 70in turbo force side discharge mower
Table of Contents

Advertisement

Figure 86
Either dipstick will be used in the machine
1. Full
2. Add
WARNING
Hydraulic oil escaping under pressure can
penetrate skin and cause injury.
• If hydraulic oil is injected into the skin it
must be surgically removed within a few
hours by a doctor familiar with this type
of injury. Gangrene may result if this is
not done.
• Keep body and hands away from pin hole
leaks or nozzles that eject high pressure
hydraulic oil.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Make sure all hydraulic oil hoses and lines
are in good condition and all hydraulic
connections and fittings are tight before
applying pressure to hydraulic system.
G015459
3. H –means high level
4. Dipstick locations under
seat
Replacing the Hydraulic Filters and
Hydraulic Oil
Service Interval: After the first 250 hours—Change the
hydraulic filters and hydraulic oil when
using any type of oil.
Every 250 hours—Change the hydraulic filters and
hydraulic oil when using Mobil
dirty or dusty conditions).
Every 500 hours—Change the hydraulic filters and
hydraulic oil when using Toro
hydraulic oil (more often in dirty or dusty conditions).
To replace the hydraulic oil, the filters need to be removed.
Replace both at the same time. Refer to the oil specifications
under Servicing the Hydraulic System (page 53) for the
correct oil.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Raise the machine and support it with jack stands
(Figure 87).
1. Jack stands
4. Remove both the mower belt and the pump drive belt.
This will prevent oil getting on the belts. Refer to Belt
Maintenance (page 49).
5. Place a drain pan under the filter, remove the old filter
and wipe the surface clean (Figure 88).
54
®
1 oil (more often in
®
HYPR-OIL
Figure 87
500

Advertisement

Table of Contents
loading

This manual is also suitable for:

74940Z master professional 6000 series

Table of Contents