Operation; Starting The Hedge Trimmer; Rotating The Hedge Trimmer Handle - Toro 51496A Operator's Manual

Symbol
DC
A
Hz
SPM
V
Setup
Cut the zip-tie away from your body and remove it from the trigger
handle (Figure 1).
1. Zip-tie

Operation

Important: The battery pack is not fully charged when
it is purchased. Before using the hedge trimmer for the
first time, refer to Charging the Battery Pack (page
Make sure to read all safety precautions. If storing for
a prolonged period of time, remove the battery. When
ready to use again, charge the battery pack; refer to
Charging the Battery Pack (page

Starting the Hedge Trimmer

1. Remove the protective cover from the cutter blades
2).
WARNING
The hedge trimmer blades can cause cuts or
amputation.
Be careful when handling the hedge trimmer with
the protective cover removed.
Name
Direct current
Amperes
Hertz
Strokes per minute
Volts
Figure 1
6).
1. Protective cover
2. Align the tongue of the battery pack with the cavity in the
handle housing
6).
1. Auxiliary handle
2. Lock switch
3. Trigger
3. Grasp the trigger handle
(Figure
4. Push the battery pack into the handle until the latch locks
into place.
5. Place one hand on the trigger handle. Place the other hand
on the auxiliary handle
6. Slide the lock switch backwards, towards you, then squeeze
the trigger switch to turn on the hedge trimmer
The trimmer will stay on as long as the trigger switch is
squeezed. Lock-off switch may be released once hedge
trimmer is running
Rotating the Hedge Trimmer
Handle
1. Press and hold the rotational lock button.
5
Designation/Explanation
Type of current
Current
Frequency (cycles per second)
Speed of blade
Voltage
Figure 2
(Figure 3).
Figure 3
4. Tongue
5. Latch
(Figure 3).
(Figure 3).
(Figure 3).
G016138
(Figure 3).