Toro 22317 Operator's Manual page 12

Attachment Tilt Lever
To tilt the attachment forward, slowly push the attachment
tilt lever forward.
To tilt the attachment rearward, slowly pull the attachment
tilt lever rearward.
Loader Arm Lever
To lower the loader arms, slowly push the loader arm lever
forward.
To raise the loader arms, slowly pull the loader arm lever
rearward.
Auxiliary Hydraulics Lever
To operate a hydraulic attachment in forward direction, slowly
pull the auxiliary hydraulics lever upward and then rearward.
To operate a hydraulic attachment in reverse direction, slowly
pull the auxiliary hydraulics lever upward and then push it
forward. This is also called the detent position because it does
not require operator presence.
Speed Selector Lever
Move the speed selector lever to the forward position to set
the traction drive, loader arms, and attachment tilt to high
speed and the auxiliary hydraulics to low speed.
Move the speed selector lever to the rearward position to set
the auxiliary hydraulics to high speed and the traction drive,
loader arms, and attachment tilt to low speed.
WARNING
If you move the speed selector lever while the
traction unit is in motion, the traction unit will
either stop suddenly or accelerate quickly. If you
operate the traction unit with the speed selector
lever in an intermediate position, the traction unit
will operate erratically and may be damaged. You
could lose control of the traction unit and injure
bystanders or yourself.
• Do not move the speed selector lever when the
traction unit is in motion.
• Do not operate the traction unit when the speed
selector is in any intermediate position (i.e.,
any position other than fully forward or fully
rearward).
Hour Meter
The hour meter displays the number of hours of operation
that have been logged on the traction unit.
After 50 hours and then every 100 hours thereafter (that is at
150, 250, 350, etc.) the screen displays CHG OIL to remind
you to change the oil. After every 100 hours, the screen
displays SVC to remind you to perform the other maintenance
procedures based on a 100, 200, or 400 hour schedule. These
reminders come on starting three hours prior to the service
interval time and flash at regular intervals for six hours.
12