Toro 74902TE Operator's Manual page 57

1
Figure 89
1. Deck lift pedal
2. Height of cut pin
6. Insert the height adjustment pin into the 7.6 cm (3
inch) cutting height location.
7. Release the transport lock and allow the deck to lower
to the cutting height.
8. Raise the discharge chute.
9. On both sides of the deck, measure from the level
surface to the front tip of the blade (Postion A). The
measurement should read 7.6 mm (3 inches) (Figure
90).
Figure 90
1. 7.6 cm (3 inches) at A is
correct
2. 8.3 cm (3-1/4 inches) at B
is correct
3
G017027
3. Transport lock
3. Measure here from the
blade tip to hard surface
4. Measure at A and B on
both sides
10. Fine-tune the adjustment nut on the front deck lift
assembly by turning it (Figure 91).
To increase the height, turn the adjustment nut
clockwise; to decrease, turn counterclockwise.
2
2
1
G012430
1. Adjustment nut
2. Jam Nut
11. If the front deck links do not have enough adjustment
to achieve accurate cut height , the single point
adjustment can be utilized to gain more adjustment.
12. To adjust the single point system, loosen the two bolts
at the bottom of the height of cut plate. Refer to Figure
92.
57
3 4
2 1
Figure 91
3. Rear deck adjustment
4. Front deck adjustment