Toro 74906 Operator's Manual page 56
With 52in, 60in, or 72in turbo force side discharge mower
Hide thumbs
Also See for 74906:
- Operator's manual (72 pages) ,
- Operator's manual (80 pages) ,
- Operator's manual (76 pages)
Table of Contents
Advertisement
Figure 89
Either dipstick will be used in the machine
1. Full
2. Add
WARNING
Hydraulic oil escaping under pressure can
penetrate skin and cause injury.
• If hydraulic oil is injected into the skin it
must be surgically removed within a few
hours by a doctor familiar with this type
of injury. Gangrene may result if this is
not done.
• Keep body and hands away from pin hole
leaks or nozzles that eject high-pressure
hydraulic oil.
• Use cardboard or paper to find hydraulic
leaks.
• Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
• Make sure that all hydraulic oil hoses
and lines are in good condition and all
hydraulic connections and fittings are
tight before applying pressure to hydraulic
system.
G015459
3. H—means high level
4. Dipstick locations under
seat
Replacing the Hydraulic Filters and
Hydraulic Oil
Service Interval: After the first 250 hours—Change the
hydraulic filters and hydraulic oil when
using any type of oil.
Every 250 hours—Change the hydraulic filters and
hydraulic oil when using Mobil
dirty or dusty conditions).
Every 500 hours—Change the hydraulic filters and
hydraulic oil when using Toro
hydraulic oil (more often in dirty or dusty conditions).
To replace the hydraulic oil, you must remove the filters.
Replace both filters at the same time. Refer to the oil
specifications under
Servicing the Hydraulic System (page
55)
for the correct oil.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the
and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Raise the machine and support it with jack stands
(Figure
90).
1. Jack stands
4. Remove both the mower belt and the pump drive belt.
This will prevent oil getting on the belts. Refer to
Maintenance (page
5. Place a drain pan under the filter, remove the old filter
and wipe the surface clean
56
®
1 oil (more often in
®
HYPR-OIL
-
NEUTRAL
LOCK
Figure 90
51).
(Figure
91).
™
500
position
Belt
Advertisement
Table of Contents
