Toro 74906 Operator's Manual page 32

Figure 42
5. Grease the drive belt idler arm
Figure 43
6. Remove the dust cap and adjust the caster pivots.
Note: Keep the dust cap off until greasing is complete.
Refer to Adjusting the Caster Pivot Bearing (page
7. Remove the hex plug.
8. Thread a grease fitting into the hole.
9. Pump grease into the fitting until it oozes out around
the top bearing.
10. Remove the grease fitting from the hole.
11. Install the hex plug and dust cap
G009029
(Figure 42).
46).
(Figure 44).
32
Raise the front of the machine up and support it with jack
stands.
g027339
Figure 44