Gigabyte GA-X170-Extreme ECC User Manual page 68

Step 3:
On the Intel RSTe SATA Controller menu, press <Enter> on Create RAID Volume to enter the Create RAID
Volume screen. Enter a volume name with 1~16 letters (letters cannot be special characters) under the Name
item and press <Enter>. Then, select a RAID level (Figure 4). RAID levels supported include RAID 0(Stripe),
RAID 1(Mirror), Recovery, RAID 10, and RAID 5 (the selections available depend on the number of the hard
drives being installed). Next, use the down arrow key to move to Select Disks.
Step 4:
Under Select Disks item, select the hard drives to be included in the RAID array. Press the <Space> key on
the hard drives to be selected (selected hard drives are marked with "X"). Then set the stripe block size (Figure
5). The stripe block size can be set from 4 KB to 128 KB. Once you have selected the stripe block size, set
the volume capacity.
Configuring a RAID Set
Figure 4
Figure 5
- 68 -