Gigabyte GA-X170-Extreme ECC User Manual page 11

Storage Interface Š Chipset:
- 2 x M.2 connectors (Socket 3, M key, type 2242/2260/2280 SATA and PCIe
x4/x2/x1 SSD support)
* I f the iRSTe Support item in BIOS Setup is set to Enabled, the RAID function will
- 3 x SATA Express connectors
- 6 x SATA 6Gb/s connectors (SATA3 0~5)
- S upport for RAID 0, RAID 1, RAID 5, and RAID 10
* R efer to "1-10 Internal Connectors," for the supported configurations with the M.2,
ASMedia
Š
- 2 x SATA 6Gb/s connectors (SATA3 6~7), supporting AHCI mode only
USB Chipset:
Š
- 5 x USB 3.0/2.0 ports on the back panel
- 4 x USB 2.0/1.1 ports (available through the internal USB headers)
Chipset+Renesas
Š
- 4 x USB 3.0/2.0 ports (available through the internal USB headers)
Chipset+Intel
Š
- 1 x USB Type-C
- 1 x USB 3.1 Type-A port (red) on the back panel
Internal 1 x 24-pin ATX main power connector
Š
Connectors 1 x 8-pin ATX 12V power connector
Š
2 x M.2 Socket 3 connectors
Š
3 x SATA Express connectors
Š
8 x SATA 6Gb/s connectors
Š
1 x CPU fan header
Š
1 x water cooling fan header (CPU_OPT)
Š
3 x system fan headers
Š
1 x front panel header
Š
1 x front panel audio header
Š
2 x USB 3.0/2.0 headers
Š
2 x USB 2.0/1.1 headers
Š
1 x Trusted Platform Module (TPM) header
Š
1 x serial port header
Š
1 x Clear CMOS jumper
Š
1 x power button
Š
1 x reset button
Š
1 x Clear CMOS button
Š
1 x audio gain control switch
Š
Voltage Measurement Points
Š
1 x BIOS switch
Š
become unavailable when an M.2 PCIe SSD is installed. (Refer to Chapter 2, "BIOS
Setup," "Peripherals," for more information.)
SATA Express, and SATA connectors.
ASM1061 chip:
®
USB 3.0 Hub:
®
USB 3.1 Controller:
®
port on the back panel, with USB 3.1 support
™
- 11 - Hardware Installation