Preparing For Maintenance; Recommended Maintenance Schedule - Toro 38611 Operator's Manual

Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance Service
Interval
After the First
2 Operating Hours
Annually
Important: You can find more information about maintaining and servicing your snowthrower at www.Toro.com.

Preparing for Maintenance

1. Move the snowthrower to a level surface.
2. Stop the engine and wait for all moving parts to
stop.
3. Remove the ignition key.
4. After performing the maintenance procedure(s),
insert the ignition key.
Maintenance Procedure
Inspect the traction cable and adjust it if necessary. Refer to Checking and
Adjusting the Traction Cable on page 15.
Inspect the auger/impeller cable and adjust it if necessary. Refer to Checking
and Adjusting the Auger/Impeller Cable on page 16.
Check the skids and the scraper and adjust them if necessary. Refer to
Checking and Adjusting the Skids and Scraper on page 15.
Inspect the traction cable and adjust or replace it if necessary. Refer to Checking
and Adjusting the Traction Cable on page 15.
Inspect the auger/impeller cable and adjust or replace it if necessary. Refer to
Checking and Adjusting the Auger/Impeller Cable on page 16.
Inspect the spark plug. Replace and/or gap it if necessary. Refer to Inspecting
and Replacing the Spark Plug on page 18.
Check the auger gearbox oil and add oil if necessary. Refer to Checking the
Auger Gearbox Oil Level on page 17.
Check the tire pressure and inflate them to the proper pressure. Refer to
Checking the Tire Pressure on page 8.
Lubricate the hex shaft. Refer to Lubricating the Hex Shaft on page 17.
Remove the fuel and run the engine to dry out the fuel tank and the carburetor at
the end of the snowthrowing season. Refer to Storage on page 19.
Have an Authorized Service Dealer inspect and replace the traction drive belt
and/or the auger/impeller drive belt if necessary.
3329-784
14