Engine Oil - Toro 73542 Operator's Manual

Maintenance
3. Put one or two ounces of oil on the element (Fig.
24). Squeeze the element to distribute the oil.
IMPORTANT: Replace the foam element if it
is torn or worn.
1
Figure 24
1. Foam element
Checking the Paper Element
Inspect the element for tears, an oily film, and
damage to the rubber seal (Fig. 25).
IMPORTANT: Never clean the paper element
with pressurized air or liquids, such as
solvent, gas, or kerosene. Replace the element
if it is damaged or cannot be cleaned
thoroughly.
2
Figure 25
1. Paper element
IMPORTANT: To prevent engine damage,
always operate the engine with the complete
foam and paper air cleaner assembly
installed.
26
2
m–3247
2. Oil
1
m–3248
2. Rubber seal
Installing the Foam and Paper Elements
1. Carefully slide the foam element onto the paper
air cleaner element (Fig. 23).
2. Slide the air cleaner assembly and cover onto the
long rod. Now screw the cover nut finger-tight
against the cover (Fig. 23).
Note: Make sure the rubber seal is flat
against the air cleaner base and cover.
3. Install the air cleaner cover and hook latches
(Fig. 23).
4. Close the hood.

Engine Oil

Service Interval/Specification
Change oil:
After the first 5 operating hours.
After every 100 operating hours.
Oil Type: Detergent oil (API service SG or SH)
Crankcase Capacity: w/filter, 2.1 qts. (2.0 l)
Viscosity: See the table below.
USE THESE SAE VISCOSITY OILS
–20 0 20
32
F
–30 –20 –10
C
40 60 80
0 10 20 30
100
40