Positioning The Seat; Adjusting The Motion Control; Levers; Pushing The Machine By Hand - Toro 74419 Operator's Manual

Positioning the Seat

The seat can move forward and backward.
Position the seat where you have the best control
of the machine and are most comfortable.
1. Raise the seat and loosen the adjustment knobs
enough to move the seat (Figure 13).
Important: Make sure that the spacers
stay in place when loosening the knobs
to move the seat. Loss of the spacers can
result in damage to the seat.
2. Move the seat to the desired position and
tighten the knobs.
Figure 13
1. Adjustment knobs
Adjusting the Motion
Control Levers
The motion control levers can be adjusted higher
or lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever
to the control arm shaft (Figure 14).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 14).
Figure 14
1. Control lever
2. Bolt
3. Repeat the adjustment for the opposite control
lever.
Pushing the Machine by
Hand
Important: Always push the machine
by hand. Never tow the machine because
damage may occur.
To Push the Machine
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to
park position, stop the engine, remove the key,
and wait for all moving parts to stop before
leaving the operating position.
3. Raise the seat to access the bypass levers
(Figure 15).
4. Move the two bypass levers forward and then
outward to lock them in place as shown in
Figure 15.
5. Move the motion control levers inward to
disengage the parking brake.
The machine is now able to be pushed by hand.
19
3. Control arm shaft