Table of Contents
Advertisement
Installation
Loose Parts
Note:
Use the chart below to identify parts used for assembly.
DESCRIPTION
Discharge chute
Spring
Bolt 3/8–24 x 3–1/2"
Lock nut 3/8"
PTO drive belt
Pulley box
Operator's Manual
Mower Preparation
Install the Discharge Chute
1.
Place the springs into the brackets on the mower
with the hooked ends over the raised back of the
bracket (Fig. 1).
2.
Align the discharge chute with the holes in the
brackets and the spring straight ends in the space
under the hinge and above the chute (Fig. 1).
3.
Secure the chute to the bracket with bolts
through the discharge chute, springs and
brackets. Secure with lock nuts (Fig. 1).
4.
Lift the discharge chute and check that it is
spring loaded and pivots freely to the full down
position.
IMPORTANT: Discharge chute must be
spring loaded in the down position. Lift the
chute up to test that it snaps to the full down
position.
QTY.
1
2
Install discharge chute
2
2
1
Install PTO drive belt
1
Install pulley box
1
Read before operating
5
1. Bracket
2. Spring hook end
3. Space for spring
USE
6
3
4
Figure 1
4. Discharge chute
5. Bolt
6. Lock nut
1
2
m–3484
3
Advertisement
Table of Contents
