Using The Grass Bag; Rear Discharge - Toro 20833 Operator's Manual

3. Lift up or press down on the handle, and use the pointer
and the cutting height setting on the link rod to set the
lawn mower to the desired cutting height (Fig. 15).
2
1
Figure 15
1. Link rod
2. Cutting height setting

Using the Grass Bag

Installing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Open the rear door (Fig. 1).
3. Hold the spring-loaded rear door up to prevent it from
closing.
4. Hang the grass bag frame pins onto the hooks as shown
in Figure 16.
1
Figure 16
1. Hook (2)
5. Release the rear door.
3
3. Pointer
2
2. Grass bag frame pin (2)
10
Mowing with the Grass Bag
Warning
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's
or bystander's direction and result in serious
personal injury or death to the operator or
bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
Cut the grass until the bag is full.
Important Do not overfill the bag.
Removing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
Danger
If the rear door does not close completely, the lawn
mower could throw objects, causing serious
personal injury or death.
If you cannot close the rear door because the grass
clippings clog the discharge area, stop the engine,
wait for all moving parts to stop, and remove the
grass clippings (with a stick, not your hand) until
the rear door closes completely.
2. Open the rear door (Fig. 1).
3. Hold the spring-loaded rear door up to prevent it from
closing while you remove the grass bag.
4. Lift the grass bag frame pins off the hooks and out of
the opening as shown in Figure 16.

Rear Discharge

Occasionally, you may need to cut the lawn without the
grass bag when the grass is too long for bagging.
To use the rear discharge feature, remove the grass bag
(refer to Removing the Grass Bag on page 10), and close
the rear door.