Table of Contents
Advertisement
Product Overview
1
2
1. Handle-adjustment knob
2. Throttle handle
3. ProPitch handle (Models
68049 and 68051 only)
g019519
5
1
g020316
Figure 3
4. Dyna-Clutch lever
5. Tilt-adjustment knob
(Models 68048 and 68050
only)
3
4
3
4
5
6
1. Lifting point
2. Fuel-tank cap
3. Choke lever
4. Fuel valve
2
Controls
4
Recoil-starter Handle
Pull the recoil-starter handle to start the engine (Figure 4).
Fuel Valve
Close the fuel valve when transporting or storing the machine
(Figure 4).
Choke Lever
Use the choke lever (Figure 4) to start a cold engine. Before
pulling the recoil-starter handle, move the choke lever to the
closed position. Once the engine is running, move the choke
lever to the open position.
Note: A warm engine requires little or no choking.
Engine On/Off Switch
The On/Off switch (Figure 4) allows the operator of the
machine to start and stop the engine. This switch is located
on the front of the engine. Rotate the On/Off switch to the
On position to start and run the engine. Rotate the On/Off
switch to the Off position to stop the engine.
6
1
2
g021560
Figure 4
5. Sediment cup
6. Recoil-starter handle
7. Engine On/Off switch
7
Advertisement
Table of Contents
