Storage - Toro 68048 Operator's Manual

Storage

1. Set the Dyna-Clutch lever to the Stop position, stop
the engine, and disconnect the spark plug wire.
2. Remove dirt and grime from the entire machine.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the engine.
3. Service the air cleaner; refer to Servicing the Air
Cleaner (page 14).
Change the engine oil; refer to Servicing the Engine
Oil (page 15).
4. For storage over 30 days, prepare the machine as
follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow the mixing instructions
from stabilizer manufacturer (1 oz. per gallon).
Do not use an alcohol based stabilizer
(ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and used
at all times.
B. Run the engine until it stops from running out
of fuel.
C. Choke the engine.
D. Start and run the engine until it will not start again.
E. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store stabilizer/conditioned
gasoline over 90 days.
5. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
6. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
7. Store the machine in a clean, dry garage or storage area.
8. Cover the machine to protect it and keep it clean.
22