Adjusting Center Gage Wheels - Toro 30260 Operator's Manual

4
3
2
Figure 21
1. Gage Wheel
2. Stud
3. Washer

Adjusting Center Gage Wheels

The gage wheels must be adjusted in the proper hole
location for each height-of-cut position.
1. After adjusting height-of-cut remove bolt, washers and
nut (Fig. 22).
2. Select a hole position so the gage wheels are a
minimum of 3/8 in. (10 mm) off the ground for the
height-of-cut to be used (Fig. 22).
3. Reinstall the bolt, washers and nut (Fig. 22).
3
4
1
Figure 22
1. Center Gage Wheels and
Spacer
2. Nut
1
5
m–5201
4. Nut
5. Wheel nut and washer.
Do Not Remove.
4
2
m–5200
3. Bolt
4. Washer
22