Toro 74919TE Operator's Manual page 57

10. Fine-tune the adjustment nut on the front deck lift
assembly by turning it (Figure 86).
Note: To increase the height, turn the adjustment
nut clockwise; to decrease the height, turn the nut
counterclockwise.
2
1
G012430
Figure 86
1. Adjustment nut
2. Jam nut
11. If the front deck links do not have enough adjustment
to achieve accurate cut height, the single point
adjustment can be utilized to gain more adjustment.
12. To adjust the single point system, loosen the 2 bolts at
the bottom of the height-of-cut plate. Refer to Figure
87.
3 4
2 1
3. Rear deck adjustment
4. Front deck adjustment
1. Bolts at the bottom of the height-of-cut plate
13. If the deck is too low, tighten the single point
adjustment bolt by rotating it clockwise. If the deck is
too high, loosen the single point adjustment bolt by
rotating it counterclockwise (Figure 88).
Note: Loosen or tighten the single point adjustment
bolt enough to move the height-of-cut plate mounting
bolts at least 1/3 the length of the available travel
in their slots. This will regain some up and down
adjustment on each of the four deck links.
1. Single point adjustment bolt
14. Tighten the 2 bolts at the bottom of the height of cut
plate (Figure 87). Torque to 37 to 45 N-m (27 to 33
ft-lb).
Note: In most conditions, the back blade tip should
be adjusted 6.4 mm (1/4 inch) higher than the front.
57
Figure 87
g017036
Figure 88
1
g017029