Bagging The Clippings - Toro Super Recycler 20382 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
Note: Ensure the bag is seated in the correct position.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown toward you or
bystanders, resulting in serious personal injury or
death.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side-discharge chute is on the machine, remove it
and lock the side-discharge door; refer to
Side-Discharge Chute (page 14)
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
1. Route the starter rope around the lower-rope guide
(Figure 21).
G017483
1. Lower-rope guide
Note: The lower-rope guide releases the starter rope
when you pull the recoil-start handle.
2. Raise and hold up the discharge deflector
Removing the
before bagging the clippings.
Figure 21
(Figure
1. Discharge deflector
3. Pull out the rear-discharge plug
4. Hang the upper front edge of the bag on the notches
(Figure 23).
G017484
1. Discharge deflector
Note: Ensure that the grass bag is securely installed
onto the machine.
5. Lower the discharge deflector.
22).
12
G017464
Figure 22
2. Rear-discharge plug
(Figure 22).
Figure 23
2. Grass bag