Operating Tips - Toro Super Recycler 20382 Operator's Manual

Figure 27
1. Discharge deflector
Note: To unlock the plug, rotate the lever on the plug to the
right (Figure 26).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Side-Discharge Chute
1. Unlock the side-discharge door
Figure 28
2. Lift open the side-discharge door
Figure 29
3. Install the side-discharge chute and close the door onto
the chute (Figure 30).
G017463
2. Rear-discharge plug
(Figure 28).
(Figure 29).
Removing the Side-Discharge Chute
To remove the side-discharge chute, reverse the steps above.
Important: Lock the side-discharge door after you close
it (Figure 31).

Operating Tips

General Mowing Tips
•
Clear the area of sticks, stones, wire, branches, and other
debris that the blade could hit.
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately stop the engine, disconnect the wire from
the spark plug, and examine the machine for damage.
•
For best performance, install a new blade before the
cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
•
Cut only about a third of the grass blade at a time. Do not
cut below the 51 mm (2 inch) setting unless the grass is
sparse or it is late fall when grass growth begins to slow
down. Refer to Adjusting the Cutting Height (page
•
When cutting grass over 15 cm (6 inches) tall, mow at the
highest cutting-height setting and walk slower; then mow
again at a lower setting for the best lawn appearance. If
the grass is too long, the machine may plug and cause
the engine to stall.
14
Figure 30
Figure 31
10).