Installing The Fuel Tank And The Fuel Line; Installing The Discharge Tunnel Plug - Toro 22177TE Operator's Manual

Note: You can adjust the handle height for comfortable
operation. Stand behind the handle to determine the
height. To adjust the handle height, position the cap
screws and the locknuts that secure the handle latches to
the handle into the other mounting holes in the latches.
3. Slide the bag support rod through the second from the
top mounting holes in the handle and secure each end
with a cap locknut (Fig. 2).
4. Use a cable tie to secure the control cables to the left
handle below the bag support rod.
Installing the Fuel Tank and the
Fuel Line
1. Start the two self-tapping screws into the bottom of the
fuel tank and then remove the screws (Fig. 3).
3
2
1
Figure 3
1. Tank base
2. Fuel tank bracket
3. Plastic clips
2. Hook the plastic clips on the front of the fuel tank onto
the fuel tank bracket (Fig. 3).
3. Secure the fuel tank to the tank base with the two
self-tapping screws (Fig. 3). Do not overtighten the
screws.
4. Remove the red cap from the end of the fuel line and
from the end of the elbow fitting on the fuel tank
(Fig. 4).
4
5
530
4. Fuel tank
5. Self-tapping screw (2)
Figure 4
1. Fuel line
2. Elbow fitting
5. Slide the end of the fuel line onto the elbow fitting
(Fig. 4).
6. Secure the fuel line in place with the fuel line clamp
(Fig. 4).
Installing the Discharge Tunnel
Plug
1. Open the discharge door by pulling forward on the
handle and moving it rearward (Fig. 5). Hold the
discharge door handle to prevent the spring-loaded
door from closing while you insert the plug.
Figure 5
1. Discharge door handle
2. Since the plug is slightly wider than the discharge
tunnel opening, rotate the plug clockwise slightly
while inserting it (Fig. 5).
Note: Ensure that the arrow on the plug decal points
upward.
8
2
3
1
m-7283
3. Fuel valve
1
2
m-1914
2. Plug rotated clockwise