Cleaning; Cleaning Under The Mower Housing - Toro 22295 Operator's Manual

Balancing the Blade
1. Check the balance of the blade by placing the center
hole of the blade over a nail or screwdriver shank
clamped horizontally in a vise (Figure 25).
Figure 25
Note: You can also check the balance using a
commercially manufactured blade balancer.
2. If either end of the blade rotates downward, file that
end (not the cutting edge or the end near the cutting
edge) until neither end of the blade drops.
Installing the Blade
1. Install a sharp, balanced Toro blade, the accelerator, the
lock washer, and the blade bolt. The sail of the blade
must point toward the top of the mower housing for
proper installation.
Note: Torque the blade bolt to 68 N-m (50 ft-lb).
WARNING
Operating the machine without the accelerator
in place can cause the blade to flex, bend, or
break, resulting in serious injury or death to
you or to bystanders.
Do not operate the machine without the
accelerator in place.
2. Return the machine to the operating position.

Cleaning

Cleaning under the Mower
Housing
To ensure the best performance, keep the underside of the
mower housing clean. Be especially careful to keep the kickers
free of debris (Figure 26).
1. Kickers
Washing Method
Service Interval: Before each use or daily
WARNING
The machine may dislodge material from under the
mower housing.
• Wear eye protection.
• Stay in the operating position (behind the
handle) while the engine is running.
• Do not allow bystanders in the area.
1. Position the machine on a flat concrete or asphalt
surface near a garden hose.
2. Start the engine.
3. Hold the running garden hose at handle level and direct
the water to flow on the ground just in front of the
right rear tire (Figure 27).
1. Right rear wheel
20
Figure 26
Figure 27