Toro 30241 Groundsmaster 228-D Operator's Manual page 19

Temperature Override Switch
Press and hold the over-ride switch (Fig. 9) to start the
engine after a high-temperature shut down. Use only
for emergency operation.
Throttle
The throttle (Fig. 9) is used to operate the engine at
various speeds. Moving the throttle forward increases
engine speed—FAST; rearward decreases engine
speed—SLOW. The throttle controls the speed of the
cutter blades and, with the traction pedal, controls the
traction unit's ground speed.
Hour Meter
The hour meter (Fig. 9) registers accumulated hours
of engine operation.
Engine Coolant Temperature Warning
Light
The light illuminates and the engine shuts down when
coolant reaches an excessively high temperature
(Fig. 9).
Glow Plug Indicator
When lit, indicates that the glow plugs are on (Fig. 9).
Charge Indicator
Illuminates when the system's charging circuit
malfunctions (Fig. 9).
Oil Pressure Warning Light
The oil pressure warning light (Fig. 9) glows when
engine oil pressure drops below a safe level. If low oil
pressure occurs, stop the engine and determine the
cause. Repair the damage before starting the engine
again.
Lift Lever Lock
Lock the lift lever (Fig. 9) in the raised position when
performing maintenance on the cutting unit.
Seat Adjusting Handle
To adjust the seat, loosen the adjusting knobs and
slide the seat to the desired position. Tighten the
knobs to lock the seat in place.
Seat Adjusting Handle—Deluxe Seat
To adjust the seat, move the lever on the left side
outward, slide the seat to the desired position and
release the lever so it will lock in that position.
19