Transaxle Fluid - Toro 72105 Wheel Horse 268HE Operator's Manual

Maintenance
Adjusting Toe-In
1. Check the toe-in before you adjust it; refer to
Measuring Toe-In, Page 31.
2. Remove ball joint from one steering lever
(Fig. 32).
3. Loosen jam nut securing ball joint to steering
rod. Rotate ball joint one turn, clockwise to
increase or counter clockwise to decrease toe-in.
4. Hold flats on ball joint to align with flats on tie
rod and tighten jam nut (Fig.32 ).
5. Install ball joint to steering lever and check the
toe-in; refer to Measuring Toe-In, Page31.
IMPORTANT: If more than one turn is
required to meet specifications, alternate
between left and right steering rods to
maintain steering wheel alignment.
32

Transaxle Fluid

Service Interval/Specification
Check fluid level after every 100 hours or yearly
whichever comes first. Always keep the fluid level at
the full level when the transaxle is cold. The transaxle
is a sealed system and no changing of the fluid is
required.
Fluid Type: SAE 10W–30 Detergent oil (API service
SF or SG)
Checking Fluid Level
1. Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
and turn the ignition key to "OFF" to stop the
engine. Remove the key.
2. Open the hood.
3. Clean around the fluid reservoir (Fig. 33) so
level is clearly visible and so dirt cannot fall into
the reservoir if fluid is added.
4. When transaxle is cold add oil to "Full Cold"
line on reservoir (Fig. 33).
IMPORTANT: Do not fill above the full cold
line as fluid may overflow.
1
Figure 33
1. Fluid reservoir
2
1243
2. Full cold level